Amana ModernMaid Owner's Manual page 8

6. Assemble water valve coupling by removing nut
and sleeve from adapter fitting. Slide brass nut
and sleeve over end of copper tubing. Insert
copper tubing completely into adapter fitting.
Confirm hose washer is in place by checking
adapter fitting. Tighten adapter fitting by hand.
Tighten an additional 1/2 turn using an
adjustable wrench. Connect nut on copper
tubing to adapter fitting. Confirm copper tubing
is secure by pulling on copper tubing.
7. Turn on water supply to refrigerator and check
for leaks. Turn off water supply to refrigerator
and correct any leaks. Repeat this process until
no leaks are found, then completely turn on
water supply to refrigerator.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, all back
covers must be installed before plugging
in refrigerator.
8. Replace lower back cover by reversing step 5.
Tuck wires inside cover. Avoid pinching wires.
9. Create service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator
cabinet using "P" clamp.
10. Plug in refrigerator. While refrigerator is
operating, check for leaks. Confirm water inlet
tube in freezer section remains firmly in place.
11. Move refrigerator in place.
Hose Washer
Adapter Fitting
8
Brass Sleeve
Brass Nut
"P" Clamp