Control During Operation - CYBEX Pro3 Owner's Manual

Control During Operation

Control keys on the display are usable during operation and may be pressed at any time to make
adjustments in speed, elevation or data readouts.
Changing Speed – Press the Speed + – keys to change the speed in increments of 0.1 mph or 0.10 kph.
Minimum to maximum speed is from 0.5 - 12.4 mph (0.8 - 20 kph). NOTE: During a Manual or Quick Start
workout the Λ V keys temporarily revert to speed keys.
Changing Incline – Press the Incline Λ V keys to change the elevation in increments of 1%. Elevation
ranges from -2 to 15%. NOTE: Elevation is defi ned as the ratio of rise or fall over run of the treadmill
deck.
Changing Level – You can change the level during a programmed workout. Press the Level key to
display the current program and level status. Then press Λ V keys to change the level. The level will
change immediately and will continue to accumulate performance data without interruption.
Changing Programs – When changing programs, your data will transfer from one program to another.
This also applies when changing between Manual Mode and programs.
Changing Workout Time – Press Time to alter the amount of time you plan to workout. You can change
Time before or during a workout. NOTE: The Max time may limit your time. See Setting Operation
Options in chapter 5. Time is disabled for distance based programs such as 9 Holes and 5K.
Changing Data Readouts – Press Scan once and it will continually review each set of data. Press Scan
again to continue to display a set of data. NOTE: The automatic scan is a feature that can be turned on or
off. See Setting Operation Options in chapter 5.
Quick Start Reset – Press Quick Start when within a Quick Start workout to clear all accumulated data
(time calories and distance). This can be used to reset the data after a warm-up in Quick Start workout.
Operation
Page 3-6
Cybex Pro 3 Treadmill Owner's Manual