Upload Customs; Menu Map - Chauvet COLORdash Par User Manual

Upload Customs

The custom programs in the COLORdash™ Par may be transferred (copied) from one fixture to another, thus
giving the ability to have to only program them on a single fixture, and then duplicate this only several others.
This is referenced in the Control Panel as "Upload". Follow the below steps for this process. On all fixtures that
are going to receive the upload, set them on DMX operation. The address does not matter for this operation.
1. Disconnect from DMX controller
Select "Settings" in the Control Board and press Enter.
2.
Select "Upload Customs" and press enter.
3.
Press enter. The "customs" portion of the screen will begin to flash. Press enter to confirm and begin
4.
the transfer.
5. The slave fixtures will display green if the transfer is successful. They will display red if the transfer
is unsuccessful.
Note: the units receiving the new custom programs from the master must be set to
"SLAVE". Otherwise, they will not allow receipt of the programs.

Menu Map

M F S
AIN UNCTION
Red
Green
1. Static Color
Blue
Strobe
Auto
2. Auto
Custom
3. DMX Address
4. Run
5. Personality
6. ID Address
Custom (1~10)
7. Edit Custom
-(Scene 01-30)
ID
Reset to factory?
8. Settings
Upload custom?
19. Password
COLORdash™ Par User Manual
-F S
UB UNCTION ELECTION
000 ~ 255*
(0 ~ 100%)
*Strobe range is
0~20
(1~10)
(1~10)
001 ~ 512
DMX~Slave
Stage 1
Arc 1
Arc 1+D
0-66
Red
Green
Blue
Strobe
Time
Fade
On~Off
(Press enter 2 times)
(Press enter 2 times)
On~Off
I
NSTRUCTION
User can combine Red, Green and Blue
to generate a custom color
Select strobing frequency between 0
and 20Hz
Choose from 10 automatic programs
Choose from 10 programs that be
customized under the "edit custom"
menu option
Sets the DMX starting address
Sets the operating mode for the fixture:
to receive signal from a DMX controller
(DMX) or to receive signal from the DMX
out of another fixture
9-channel RGBW+D
3-channel RGB
4-channel RGB+D
Assigns the ID address to a fixture
User can combine Red, Green and Blue
to generate a custom color (0~255)
Select strobing frequency (0 ~20Hz)
(0~255)
(0~255)
Turns ID addressing on or off
Resets the fixture to the default, factory
settings
Uploads a fixture's custom program to
another fixture (same fixture only)
Turns the password on or off (after 30s
of no action, the password will
automatically turn on after selecting On)
16
9/4/2008 12:09 PM