Using The Wireless Lan - Getac V100 User Manual

Using the Wireless LAN

Depending on your model, an internal mini PCI-E wireless LAN
(WLAN) card may have been pre-installed by your computer
manufacturer at the factory. This card allows you to access corporate
networks or the Internet in a wireless environment.
The WLAN features include:
Peer-to-Peer (Ad-Hoc) and Access Point (Infrastructure) modes
support
WEP (Wired Equivalent Privacy) 64/128-bit data encryption
IEEE 802.11a/b/g standard compliance
Technology
Stated Maximum
Throughput (Mbps)
Data Rates (Mbps)
Band (GHz)
Modulation
Technology
NOTE: 802.11g mode is backward compatible with 802.11b mode.
To take advantage of the WLAN feature, make sure that the PROSet
driver is installed correctly. (See chapter 6 for details.) If your WLAN
card was provided by your dealer instead of the computer manufacturer,
contact your dealer for the correct driver to use.
Installing the Mini PCI-E WLAN Card
In case the mini PCI-E WLAN card has not been installed in your
computer, perform the following:
1. Remove the battery pack (see chapter 3) and make sure that the
computer is not connected to AC power.
2. Carefully place the computer upside down.
Operating Your Computer
802.11a
54 11
54, 48, 36, 24, 18, 11, 5.5, 2, 1
12, 9, 6
5.15 ~ 5.35 2.412 ~ 2.462
OFDM (Orthogonal DSSS (Direct
Frequency Division Sequence Spread
Multiplexing) Spectrum)
802.11b 802.11g
54
54, 36, 18, 9
2.4
OFDM (Orthogonal
Frequency Division
Multiplexing)
2-30