Machine Care; Maintenance And Care - Bissell Lift-Off 10N4 Series User Manual

M
aintenance and care
Machine care (check regularly)
Cleaning suction gate
The suction gate automatically diverts
air when the portable deep cleaner is
detached. This should be checked and
cleaned regularly for any dirt
and debris.
1. Step on the pedal and remove the
portable spot cleaner. Remove dirty
tank.
2. Remove two screws and pull off
suction gate door.
3. Wipe suction gate clean and rinse
suction gate door.
4. Replace suction gate door and
two screws.
Cleaning spray tips
1. Step on the pedal and remove the
portable spot cleaner. To remove,
push in tab and pull it out.
2. Clean by rinsing under water.
3. Replace by snapping back in.
4. Repeat steps on second spray tip.
Cleaning solution filter
1. Step on the pedal and remove the
portable spot cleaner. Remove the
red solution filter cap on the base
of the machine by inserting a coin
or a flat head screw driver into the
slot on the top.
2. Turn counter clockwise to unscrew.
Set aside.
3. Remove the white filter by the post.
Rinse the filter under water.
4. Replace the white filter back into
the filter area.
Note: Make sure the white filter
is seated properly before replac-
ing the red solution filter cap.
5. Replace the red solution filter cap and
turn clockwise to tighten.
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of fire,
electric shock, or injury, turn
power OFF and disconnect
plug from electrical outlet
before performing maintenance
or troubleshooting.
2.
Suction
Gate
Spray
Tips
1.
2.
Solution
Filter Cap
3.
5.
Filter
13