Table of Contents
Related Manuals for Bissell Pet Hair Eraser 10N6-F SERIES
Summary of Contents for Bissell Pet Hair Eraser 10N6-F SERIES
- Page 1 USER'S GUIDE 10N6-F SERIES 220-240V Thank You Safety Instructions Product View Assembly Operations Maintenance and Care 8-13 Troubleshooting 13-14 Replacement Parts Accessories Warranty Consumer Services...
- Page 2 Your BISSELL vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate assistance.
-
Page 3: Important Safety Instructions
(Spares may be obtained from given supervision or instruction concerning your BISSELL supplier). If for any reason the use of the appliance by a person plug is cut off, it must be disposed of, as it is... -
Page 4: Product View
roduct view Handle Quick Release ™ Hose Clip Cord Wrap Stretch Hose Dusting Brush/ Carry upholstery Tool Pet TurboBrush ™ Handle Tool Crevice Tool Twist ‘n Snap™ Power Hose Cord Inner Cyclone Hose Power Switch Wand upper Tank Extension Wand Easy Post-Motor Empty... -
Page 5: Attach Handle To Vacuum
ssembly The only tool you’ll need to assemble your vacuum cleaner is a Phillips screwdriver. Attach handle to vacuum 1. Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the unit, slide the base of the handle firmly into the grooves at the top of the vacuum body. -
Page 6: Handle Positions
perations Power switch CAUTION: The Power Switch is located on the left side of the vacuum. Push the rocker To avoid personal injury switch “ON” (I) to vacuum, and “OFF” and to prevent the cleaner (O) when cleaning is complete. from falling when cleaning stairs, always place it at the bottom of the stairs. -
Page 7: Special On-Board Tools
perations Special on-board tools Your vacuum is not only a powerful carpet and rug cleaner, it’s also a Dusting Brush/ versatile above floor vacuum cleaner Upholstery Tool when you select one of the special tools. 1. Raise the handle to the upright position. Crevice Tool 2. -
Page 8: Power Cord Usage
perations Power cord usage 1. To use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there is a quick release cord wrap for easy cord removal. There is also a cord clip that is part of the upper cord Quick Release wrap where you can attach the cord Cord Wrap... -
Page 9: Emptying The Dirt Container
aintenance and care Emptying the dirt container The dirt container should to be emptied before the dirt reaches the “Full” line on the container. 1. Unplug the vacuum from electrical outlet. 2. Slide the Lock ‘n Seal Lever to the “Unlock”... -
Page 10: Check Rotating Floor Brush And Drive Belt
aintenance and care Check rotating floor brush and drive belt You should check your vacuum cleaner’ s rotating floor brush and drive belt regu- larly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. -
Page 11: Replacing Light Bulb
3. Place new drive belt over motor pulley and loop other end over rotating floor brush in the space between the bristles. NOTE: It is important that you use only genuine BISSELL replacement belts. Generic belts may not meet Motor the exact specifications required... -
Page 12: Clearing Clogs
aintenance and care Maintaining Pet TurboBrush Tool continued ™ 3. Remove the brush from the belt and clean debris. 4. Replace the brush inside the belt and place ends into slots on sides as shown. 5. Reposition top cover making sure to line up inside tab at the front with the open- ing on the cover. -
Page 13: Troubleshooting
aintenance and care Cleaning the upper tank continued The inner cyclone and filtration disk may be washed using a mild detergent. Be sure it is completely dry before reassem- bling or damage to your unit may result. Once cleaning is completed, reassemble the filtration disk over the inner cyclone by sliding it straight down on the top of the inner cyclone and turning left. -
Page 14: Please Do Not Return This Product To The Store
3. Pull out and re-insert dirt container correctly Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store. eplacement parts Item Part No. - Page 15 Warranty IS In addItIon to otHEr rIGHtS or rEMEdIES undEr LaW. notHInG In tHIS Warranty EXcLudES, LIMItS or ModIFIES any LIaBILIty oF BISSELL WHIcH IS IMPoSEd By LaW, or LIMItS or ModIFIES any rEMEdy aVaILaBLE to tHE conSuMEr WHIcH IS GrantEd By LaW. to MaKE a cLaIM undEr tHIS Warranty contact BISSELL auStraLIa Pty Ltd (dEtaILS aBoVE).
- Page 16 ISSELL consumer services If your BISSELL product should require service: Call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. If you have questions about your warranty or Or visit the BISSELL need replacement parts please contact the numbers below.