Bissell Lift-Off 10N4 Series User Manual page 12

O
perations
Portable spot cleaning mode continued
Cleaning with deep Reach™ Tool
(select models only)
1. Set tool on soiled surfaces and press
the spray trigger to spray solution onto
the soiled area to be cleaned.
2. Slowly move the tool back and forth
over the soiled surface, keeping the
tool in contact with the carpet.
Release spray trigger and move tool
slowly over the soiled area to suction
up water and dirt.
4. Continue to clean the area, working
in small sections, until no more dirt can
be removed.
Empty dirty tank
Follow the instructions under Empty
dirty tank section on page 9 of the
Upright cleaning mode section.
Replacing portable machine on base
1. Align the product as the graphic shows,
with the cord side on the left and hose
side on the right.
2. Push down the portable spot cleaner
until you hear it click securely into
place. Test the fit by pulling up on the
carry handle to make sure it is secure.
Cleaning portable machine
1. Remove and rinse the tools in clean,
running water. Dry and replace in the
tool storage provided.
2. It is recommended that you suction clean
water from a bowl to rinse out the hose.
Then lift end of hose and stretch out to
ensure all water is cleared from hose.
3. Coil flex hose around the hose wrap
and secure with latch.
4. Check suction gate and if it appears
dirty, follow steps 1-4 under Cleaning
Suction Gate on page 13.
12
w w w . b i s s e l l . c o m
1.
3.
1.
Graphic