Information From Your Isp; Protocols - Billion BiGuard 10 User Manual

IP address 192.168.1.254
Subnet Mask
255.255.255.0
DHCP server
Enabled
function
IP addresses for 100 IP addresses continuing
distribution to from 192.168.1.100 through
PCs 192.168.1.199

3.6 Information From Your ISP

Before configuring this device, you have to check with your ISP (Internet Service
Provider) to find out what kind of service is provided such as DHCP, Static IP, PPPoE,
or PPTP. The following table outlines each of these protocols:
Configure this WAN interface to use DHCP client protocol to get an IP
DHCP address from your ISP automatically. Your ISP provides an IP address to
the router dynamically when logging in.
Configure this WAN interface with a specific IP address. This IP address
Static IP
should be provided by your ISP.
PPPoE (PPP over Ethernet) is known as a dial-up DSL or cable service. It
is designed to integrate the broadband services into the current widely
PPPoE
deployed, easy-to-use, and low-cost dial-up-access networking
infrastructure.
If your ISP provides a PPTP connection, you can use the PPTP protocol
PPTP
to establish a connection to your ISP.
Big Pond The Big Pond login for Telstra cable in Australia.
If your account uses PPP over Ethernet (PPPoE), you will need to enter your login
name and password when configuring your BiGuard 2/10. After the network and
The DHCP Client is enabled to
automatically get the WAN port
configuration from the ISP.

3.6.1 Protocols

28