Handles - Grizzly G8621 Instruction Manual

Handles

The guard adjuster is used to secure the guard to
the table and to allow the guard to be loosened
for adjustment. To assemble the guard adjuster:
1. Install the bar into the shaft guide as shown
in Figure 8.
2. Line up the groove in the bar with the
setscrew.
Figure 8. Slide bar into shaft guide.
3. Tighten the shaft setscrew into the groove to
lock the bar in place as shown in Figure 9.
Figure 9. Tightening setscrew with hex key.
G8621 Heavy-Duty Sliding Table Shaper
Groove
4. Install the round knobs shown in Figure 10
onto both ends of the bar.
Figure 10. Thread round knobs onto bar.
The wheel shown in Figure 11 fits on the adjust-
ment shaft. This locks in place by tightening the
setscrew into the groove on the shaft. There is a
threaded hole on the wheel that allows for the
optional installation of a crank (not included).
Groove
Figure 11. Install wheel onto adjustment guide.
-13-