Handles - Grizzly G5913Z Owner's Manual

Handles

The guard adjuster is used to secure the guard to
the table and allow the guard to be loosened for
adjustment.
To assemble the guard adjuster:
1.
Install the bar into the shaft guide as shown
in Figure 9.
2.
Line up the groove in the bar with the set-
screw.
Groove
Figure 9. Bar into shaft guide.
3. Tighten the shaft setscrew into the groove to
lock the bar in place as shown in Figure 10.
Figure 10. Tightening setscrew with hex key.
G5913Z/G7215Z Heavy-Duty Shaper
4. Install the round knobs shown in Figure 11
onto both ends of the bar.
Figure 11. Round knobs onto bar.
The wheel shown in Figure 12 fits on the adjust-
ment shaft. This locks in place by tightening the
setscrew into the groove on the shaft. There is
a threaded hole on the wheel that allows for the
optional installation of a crank (not included).
Groove
Shaft
Groove
Figure 12. Wheel onto adjustment guide.
Setscrew
-17-