Mounting And Connecting Tips - XTZ Divine 100.33 User Manual

Mounting and connecting tips

Mounting
alternatives
Connect using the
correct phase
Overload
The initial playing
time
XTZ Divine 100.33 can be placed standing or lying
by a wall. The wall behind and beside the
loudspeaker influences both the bass level and the
bass characteristics, so please be patient and try
different distances to the rear and side walls. In
lying position you may place the speaker in the
associated cradle.
To place the speaker with a distance to the wall is
often best, to decrease influence of the wall (room).
Always connect using the correct phase, from the
+-pole on the amplifier to the +-pole on the
loudspeaker and corresponding for minus (-).
At high load during extensive time periods, there is
always the risk of overloading the driver and
amplifier.
It takes about 50 to 100 hours of initial playing
time, for the drivers to sound optimal. During this
time, the speaker may be used normally.
9 (13)
If you by accident connect the other way,
there is no risk of damage. However, the
sound will not be correct, especially in the
lower frequencies.
All loudspeakers have a limited handling
capacity for high power, so be careful not
to play extremely loud and not to increase
treble or bass settings to much.
By increasing the bass or treble from 0 to
max you will increase the power by about
16 times.