Pulleys - Grizzly G1012 Instruction Manual

Pulleys

With the bandsaw unit mounted firmly onto the
stand, the pulleys need to be installed next.
1.
Locate the upper pulley from your loose
parts. Make sure the key is in the upper pul-
ley shaft keyway as shown in Figure 12.
Figure 12. Key in wheel pulley shaft.
2.
The wheel pulley is shaped so that it must be
installed with the curved side out (look at the
side profile of the wheel pulley to determine
this shape).
3.
Align the the keyway in the pulley to the key
on the shaft and insert the wheel pulley as
far as it will go on the shaft. A few taps with
a dead blow rubber hammer may be neces-
sary to fit the wheel pulley all the way onto
the shaft.
4.
Insert one of the
the wheel pulley and tighten to the shaft as
shown in Figure 13.
G1012 18" Bandsaw
1 1
⁄ "-20 x ⁄ " setscrews into
4 4
Figure 13. Securing wheel pulley to shaft.
5.
Install the stepped pulley through the open-
ing in the bandsaw unit, directly below the
wheel pulley.
6.
Thread one of the
stepped pulley shaft, followed by a
er. Place this assembly through the opening
in the bandsaw unit and secure with another
washer and hex nut from inside the bandsaw
unit. Leave the last hex nut loose enough
that you can still move the stepped pulley for
further adjustments.
5 ⁄ "-11 hex nuts onto the
8
5 ⁄ " wash-
8
-15-