Grizzly G1012 Instruction Manual page 16

8.
Prepare the four rubber feet by placing the
5
⁄ "-18 x 1" bolts through the rubber feet and
16
5
tightening the ⁄
16
Figure 9.
Figure 9. Preparing rubber feet for installation.
9.
Install each rubber foot on the bottom of
each leg. Thread on another
to tighten the rubber foot to the leg as shown
in Figure 10.
Figure 10. Rubber foot installed.
-14-
"-18 hex nuts as shown in
5
⁄ "-18 hex nut
16
10. Flip the stand upright and adjust it back and
forth so it is level and symmetrical on the
legs. Now, tighten all of the stand bolts
(except the last stand side if you left it off) to
secure the bandsaw unit in place.
At this point, place the bandsaw on the stand.
Ensure that the bandsaw pulley shaft is posi-
tioned over the rectangular hole in the stand.
When the bandsaw is positioned on the stand,
fasten it (as shown in Figure 11) with the (4)
1
12 x 1 ⁄ " hex head bolts, washers and nuts pro-
2
vided. Tighten securely.
Figure 11. Bandsaw unit mounted to stand.
The Model G1012 can be awkward to handle
without assistance. The bandsaw unit is
also very unstable until it is permanently
mounted to the stand. Failure to use caution
during assembly could lead to serious per-
sonal injury.
1
⁄ "-
2
G1012 18" Bandsaw