Grizzly G1012 Instruction Manual page 15

Figure 5. Motor bracket attached to stand top.
4.
Mount the motor onto the motor bracket.
Secure with (4) 5 ⁄
washers and nuts. Hand-tighten for now.
5.
Place the smallest key in the groove on the
motor shaft. Line up the key on the shaft with
the pulley keyway. Slide the motor pulley
(the small triple-grooved pulley) onto the
motor shaft. Insert one of the small
1
⁄ " setscrews in the bottom of the middle pul-
4
ley groove and tighten with the included
3mm hex wrench as shown in Figure 6.
Figure 6. Securing motor pulley to motor shaft.
6.
Attach the four legs to the top of the stand
5
using the / "-18 x
16
ers and nuts provided. Do not tighten down
bolts completely at this time.
G1012 18" Bandsaw
" -18 x 3 ⁄ " hex head bolts,
16 4
1
⁄
4
1
/ " carriage bolts, wash-
2
7.
Attach the two horizontal braces to the legs
and secure with the
bolts, washers and nuts provided. Attach
one of the stand sides on the opposite side
of the pulley slot in the stand top. Your
assembly should now look like Figure 7.
Figure 7. Legs, braces, and one stand side
"-20 x
As an option, you may attach the other
stand side to the stand at this time.
Performing this step now will ease assem-
bly of this part, but it will limit your access
to the motor pulley when installing V-belts.
Figure 8. Legs, braces, and both stand sides
5
/ "-18 x
16
attached to stand
NOTICE
assembled as an option.
1
/ " carriage
2
-13-