Operating The Unit - Jensen SMPS-625 User Manual

NOTE: The speaker is not magnetically shielded and may cause color distortion on
the screen of some TVs or video monitors. To avoid this, you may need to move the
unit further away from the TV or monitor if an unnatural color shifts or image distortion
occurs.
TURNING THE SMPS-625 POWER ON/OFF
1. In power off mode, slide the POWER OFF/BLUETOOTH AND AUX SWITCH to
Bluetooth and AUX position to turn the unit ON. After about 3 seconds a beep is
heard and BLUETOOTH STATUS INDICATOR will flash in blue.
2. To turn the unit OFF, slide the POWER OFF/BLUETOOTH AND AUX SWITCH to
Power OFF position.
CAUTION: Please turn the power off the when not in use. The battery could
completed drained and you will need to recharge the unit before using it again.
Pairing (linking) a Bluetooth enabled call phone or other Bluetooth enabled
device to the speaker
1. If the SMPS-625 has never been paired with a Bluetooth device before. You need
to follow the pairing instructions below to link the SMPS-625 with your Bluetooth
device.
2. In power off mode, slide the POWER OFF/BLUETOOTH AND AUX SWITCH to
Bluetooth and AUX position. After about 3 seconds a beep is heard and
BLUETOOTH STATUS INDICTOR will flash in blue. The speaker is now ready to
pair (link) with your Bluetooth device.
 Turn on the Bluetooth function of your Bluetooth device and enable the search
or scan function to find the SMPS-625.
 Select "SMPS-625" from the device list when it appears on your device screen.
If required, enter the pass code "0000" to pair (link) the SMPS-625 with your
device.
3. After turning on the SMPS-625, a beep is heard and the unit will search for the last
paired device. The BLUETOOTH STATUS INDICATOR will flash blue. If the
speaker finds the paired Bluetooth device, a beep is heard and the BLUETOOTH
STATUS INDICATOR will stop flashing and remain lit (blue).
4. After successfully pairing (linking), you can begin playing music from your
Bluetooth device wirelessly to the speaker.
5. Press the Volume Up(+) / Down(-) button
volume level.
Notes:
1. Refer to manual of your cell phones, tablet PC, computer or other Bluetooth
enabled device for Bluetooth operation since it may vary from model to model.
2. Your Bluetooth enabled device will not play the music through the speaker,
even if connected (linked), if the device does not support A2DP profile.
3. If you are pairing (linking) your computer to the SMPS-625 using Bluetooth,
you may need to set the speaker as your computer's default sound device.
4. If the SMPS-625 is left idle for about 3 minutes without linking to any Bluetooth
enabled device, it will automatically turn off to save battery power.
Using the SMPS-625 as a Hands-free Bluetooth Speakerphone
1. Link your cell phone to the SMPS-625 via Bluetooth as described above.
2. When receiving an incoming call on your cell phone, tap the PLAY/PAUSE
BUTTON on the speaker to switch the incoming call from cell phone to the
SMPS-625. A short beep sound will be heard confirming the call is being
answered. Complete your call using the built-in microphone and speaker on the

OPERATING THE UNIT

on the speaker to adjust to the desired
E5