Add Engine Oil And Fuel - Troy-Bilt 1904 Owner's Manual

2. Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
3. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4. Insert "L" bolt through hole on left side of handle
(viewing from handle side of unit) and attach plastic
knob.Tighten knob by hand (Figure 3).
Figure 3 — Secure Handle
5. Insert carriage bolt through right side hole from
outside of unit and attach a plastic knob from inside of
unit (viewing unit from the handle side).Tighten by
hand (Figure 3).
6. Insert "J" hook into second from left slot in accessory
tray (Figure 4).
Figure 4 — Install "J" Hook on Accessory Tray
Handle
Handle
Supports
Section 3: Assembly
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 5.
Figure 5 — Slide Chemical Hose into Metal Clip
8. Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 6). Slide
chemical hose through metal clip so that it is tight but
not kinked.
Figure 6 — Slide Metal Clip onto Accessory Tray Flange

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
7