Assembly Section IMPORTANT: Read entire owner’s manual before you PREPARING PRESSURE attempt to assemble or operate your new pressure washer. WASHER FOR USE REMOVE PRESSURE If you have any problems with the assembly of your WASHER FROM pressure washer or if parts are missing or damaged, call the pressure washer helpline at 1-888-611-6708.
Section 4: Operation 10. Start the engine according to instructions given in the Place the nozzle extension through the hole on the engine owner’s manual. accessory tray, as shown in Figure 13. NOTE: If the recoil starter is hard to pull, it may be Figure 13 —...
Section 4: Operation How to Use the Spray Tips Cleaning and Applying Chemical CAUTION! CAUTION! NEVER exchange spray tips without You must attach all hoses before you locking the safety latch on the trigger. start the engine. Starting the engine without all the hoses connected and without the water turned ON will damage The quick–connect on the nozzle extension allows you to the pump.
Section 4: Operation Place the small filter end of the detergent siphoning After you have applied detergent, scour the surface tube into the detergent container. and rinse it clean as follows: Apply safety latch to spray gun. CAUTION! Keep the chemical injection tube from Remove the black chemical nozzle from the nozzle coming in contact with the hot muffler.
Maintenance Section GENERAL MAINTENANCE CAUTION! Water spraying from a leak is capable of injecting material into skin. Inspect hose each RECOMMENDATIONS time before using it. NEVER repair a high pressure hose. Replace it with another hose that exceeds the The pressure washer warranty does not cover items that have maximum pressure rating of your pressure washer.
Section Storage PREPARING THE UNIT CAUTION! You must protect your unit from freezing temperatures. Failure to do so will permanently damage FOR STORAGE your pump and render your unit inoperable. Freeze damage is not covered under warranty. Water should not remain in the unit for long periods of time.
Section Troubleshooting TROUBLESHOOTING Problem Cause Correction Low pressure spray tip installed. Replace spray tip with high pressure spray tip. Water inlet is blocked. Clear inlet. Inadequate water supply. Provide adequate water flow. Pump has following Inlet hose is kinked or leaking. Straighten inlet hose, patch leak.
Page 18
Exploded Views and Parts Lists Section EXPLODED VIEW AND PARTS LIST — UNIT Item Part # Description Item Part # Description P190156GS BASE 10 95519GS QUICK CONNECT,Wand End P187602GS HANDLE 11 95518GS QUICK CONNECT,Wand/Acc 192096GS ASSY, Billboard 12 190147GS PUSHNUT 185877GS HOSE 13 190717GS...