Section 3: Assembly; Add Engine Oil And Fuel - Troy-Bilt 0020242-1 Owner's Manual

2. Insert carriage bolt through left side hole from outside
of unit and attach a plastic knob from inside of unit
(viewing from rear of unit).Tighten by hand (Figure 2).
Figure 2 — Attach Bolts to Handle
3. Insert "L" bolts through holes on right side of handle
(viewing from rear of unit). Hold bolts in place and
attach plastic knobs from inside of handle (Figure 2).
Tighten by hand.

Section 3: Assembly

4. Place accessory tray over holes on handle (viewing
from front of unit). Push the tree clips into the holes
until they sit flat against the accessory tray (Figure 3).
Figure 3 — Attach Accessory Tray to Handle
5. Insert multi–colored ProjectPro™ nozzles and other
supplied accessories in spaces provided in accessory
tray. See "How to Use Accessory Tray".

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
7