Machine Specifications - Robot Coupe R502 Operation Manual

CAUTION:
Always connect the Robot Coupe to a grounded
outlet with Ground fault circuit interrupter
(GFCI) protection device.
Disconnect the machine from the power outlet
when not in use and when cleaning or servic-
ing the unit.
Machine must be operated and stored in a lo-
cation not subject to water drips or spray or
explosive vapors.
The machine must not be modified in any way
from its original configuration.
Should the machine malfunction or should any
part be damaged, it must not be operated until
it is repaired by a qualified technician using only
genuine Robot Coupe® repair parts.
Operating times of 5 minutes or longer can
cause processed food to increase to tempera-
tures above 125 F.
Failure to follow operating instructions or at-
tempts to operate the machine outside its de-
sign limits may create a hazardous condition
that could damage the machine and /or injure
users.
The machine must be operated on a clean sturdy
counter or table. Keep the area around and
under the machine clear to allow air circulation.
Otherwise, the motor can overheat.
I. INTRODUCTION
The Robot Coupe commercial food processor performs a host
of culinary feats. It is specifically designed for high speed and
quality vegetable processing. The Robot Coupe also provides
a wealth of safety and operating features to make volume food
preparation a pleasure rather than a chore.
This operators manual is broken down into sections giving
you detailed instructions for assembly and operation of the
continuous feed attachment and the cutter bowl attachment.
Close attention should be paid to all instructions in this manual
to ensure a long life and safe utilization of your food proces-
sor.
This manual should be kept within easy access
to all users for reference, and should be read
completely by all first time users of the machine.
CAUTION: Your Robot Coupe comes with sharp
cutting blades and or, cutting "Discs". Always
handle with safety in mind. Always wear a pair
of cut-resistant gloves when handling any cut-
ting discs or blades.
Never put nonfood items in the machine.
NOTICE: If the machine fails to operate as de-
scribed in this manual, or if the machine mal-
functions in any way, remove the machine from
use and have it serviced. Additionally, discard
all food processed at the time of the malfunc-
tion.

Machine Specifications:

Models R502 and R602 are equipped with 2 speed motors that
plug into a standard 208/240 volt 60 Hz 3 phase power outlet.
The full load amperage rating is 2.6 amps on low speed and 2.8
amps on high speed. The machines are supplied with stain-
less steel bowls: the R502 with a five quart and the R602 hav-
ing a 7 quart bowl. Both machines are supplied with s-blade
and clear polycarbonate cover. The machines are supplied
with a continuous feed attachment and 2 cutting discs as
standard equipment. Additional cutting discs are available as
optional equipment.
R502 and R602 Operation Manual
Series E versions
3