Clamp Vise - Grizzly G0659 Owner's Manual

Clamp Vise

Angle Adjustments
1.
the lock pins secure the vise angle at 90º.
For angles other than 90º, remove the lock
pins from the vise. if they do not pull out by
hand, turn the lock nuts clockwise to release
the pins from their holes (figure 18).
Clamp lock
Bolt
figure 18. Clamp vise angle.
2.
loosen the clamp lock bolt, rotate the clamp
to the desired angle, then tighten the clamp
lock bolt.
C-Clamp Vise installation
1. place the C-clamp vise over the vise base,
then insert the vise rod into the clamp base,
as shown in figure 19.
Vise rod
leadscrew
figure 19. C-clamp vise.
-18-
lock pin
lock nut
Clamp Base
2.
turn the leadscrew to tighten the clamp and
secure the workpiece. Be sure the clamp is
not in the path of the saw blade.
Note: When clamping workpieces at angles,
it may be necessary to position the clamp on
the other side of the vise to avoid interfering
with the blade travel.
C-Clamp Vise Removal
1.
remove the lock pins from the vise by turning
the lock nuts clockwise to release the pins
from the holes (figure 20).
Clamp lock
screw
Vise pin
figure 20. C-clamp vise removal.
2.
remove the clamp lock bolt and the entire
clamp vise assembly. use pliers to carefully
remove the vise pin from the table.
g0659 9" x 14" Vertical Metal-Cutting Bandsaw
lock pin
lock nut