Installation Notes - Honda CTX200 Owner's Manual

Installation Notes:

Reverse the removal procedure.
Insert the axle through the wheel hub
and left fork leg.
Make sure that the lug (6) on the
speedometer gearbox is located behind
the lug (7) on the right fork leg (8) .
Tighten the axle to the specified torque.
Front axle torque:
59 N·m (6.0 kgf·m , 43 lbf·ft)
Install the axle holder with the UP mark
( ) upward and tighten the upper holder 9
nuts to the specified torque first, then
tighten the lower holder nuts to the same
torque.
Axle holder nut torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not
rotate freely.
80
If a torque wrench was not used for
installation, see your Honda dealer as
soon as possible to verify proper
assembly. Improper assembly may lead to
loss of braking capacity.
(7)
(8)
(9)
(6) Lug
(7) Lug
(6)
(8) Right front fork
(9) UP mark