Operation - Seeley Climate Master CM12W Owner's Manual

Portable refrigerated air conditioner
Table of Contents

Advertisement

OPERATION cont.
Air Conditioner Features
Step 6:
Your air conditioner has a SLEEP
mode, activated by pressing the button on
the control panel or remote control.
SLEEP mode will change the fan speed to
low and increase (for cooling mode) or
decrease (for heating mode) the set
temperature by 1°C each hour for 2 hours.
No further change will occur after the 2nd
hour.
Step 7:
To improve air cleanliness, your
cooler may be equipped with an active
carbon filter, negative ion generator and
TiO lamp (models CM12WX, CM15WX
2
only).
Fit the active carbon filter into the upper
rear filter frame as shown (Fig 12).
A - remove side filter from unit
B - remove upper rear filter
C - unclip the frame from the rear filter
D - insert the active carbon filter and clip
the frame back into place.
Reassemble all filters back into the unit,
then press the Ion/TiO button on the
control panel or remote control to activate
this feature.
Timer Function
The air conditioner is fitted with a timer
function. This can be set up to 24 hours in
advance. To use this function, the cooler
must be plugged in and ready to operate.
Step 8: Setting the timer
With the air conditioner ON, press the
TIMER button on the remote control or
control panel. The control panel display
will flash and show the time setting. Press
the TIMER button to increase the time in 1
hour increments from 1 - 24 hrs. After 5
seconds the display will revert to the SET
temperature.
8
2
®
ClimateMaster series Portable Refrigerated Air Conditioner
When the air conditioner is OFF (but still
plugged in), repeat the above to set the ON
time. The air conditioner will start up with the
last settings used.
Note!
When the air conditioner is working, only
the TIMER OFF can be set. When the air
conditioner is off, only the TIMER ON can be
set.
How to cancel the timer
To cancel the timer, press and hold the TIMER
button on the control panel for 3 seconds or set
the time to
0
using the remote control. The
TIMER indicator will stop glowing.
12
B
A
C
D

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents