Appendix F: Web Interface Guide - Bryston SP3 Owner's Manual

SP3 PREAMP / PROCESSOR
APPENDIX F
WEB INTERFACE GUIDE
SP3 Web Interface Guide
(Draft doc 7-Feb-2012, Bryston Ltd., Stan Bleszynski)
1. General guidelines (introduction).
SP3 can be connected to a PC (Windows, MacOS, Linux etc) using Ethernet cable through a local area
1
network hub or through a direct peer-to-peer (SP3-to-PC) using a cross-over network cable .
Connection between SP3 and a PC can be established using either one of the 3 basic configuration
schemes differing in the way the IP addresses are leased out or assigned. This is described in more
details in the following document on-line:
ftp://ftp.bryston.com/pub/fw/sp3/doc/SP3_setup_using_LAN2.doc
or
ftp://bryston.com/pub/fw/sp3/doc/SP3_setup_using_LAN2.doc
2. Main screen.
Communication interface with the SP3 is handled by an internet browser, for example Internet
Explores, Chrome, Safari, etc. Once a connection is established, typing in the SP3 so-called "Net
Bios Name" or its IP address in the browser URL window and pressing enter, should bring the
following screen:
Main SP3 Web Interface Screen
1
An Ethernet cable where the Rx and Tx lines are swapped at one end of the cable. For computer-to-computer hookup (as
opposed to computer-to-hub hookup). See reference links above or in Appendix H
Web Interface Guide Pg. 1 of 6