Bryston SP3 Owner's Manual page 31

SP3 PREAMP / PROCESSOR
APPENDIX F: WEB INTERFACE GUIDE continued
Clicking on the "Upload Image File (.bin) opens up a file selection subscreen which allows selecting a
compressed firmware file (of type .bin) and then starting upload and programming. This is described
in more details in the following on-line document:
ftp://bryston.com/pub/fw/sp3/doc/UploadInstruct.doc
Note: selecting of "Restricted Default Flash Partition" allows overwriting of backup files in the SP3
flash. This option is normally not enabled.
3. Setup screen.
This screen displays network-connectivity settings and also allows modification of: DHCP mode
selection, IP address, Gateway IP address, Subnet Mask, Primary DNS and Secondary DNS.
2
MAC Address and Host Name are hard-coded and cannot be changed and saved!
2
This is the same as "Net Bios Name" referred elsewhere in the documentation.
Web Interface Guide Pg. 3 of 6