Table of Contents
Advertisement
4.4.6
Verifying Connectivity and Name Resolution
Perform the following steps to verify that the network adapters are
working properly:
Note:
Before proceeding, you must know the IP address for each
network card adapter in the cluster. You can obtain it by
using the IPCONFIG command on each node.
1. Click on Start.
2. Click on Run.
3. Type cmd in the text box.
4. Click on OK.
5. Type ipconfig /all, and press Enter. IP information is displayed for all
network adapters in the machine.
6. If you do not already have the command prompt on your screen, click
on Start.
7. Click on Run.
8. In the text box, type:
cmd
9. Click on OK.
10. Type
ping ipaddress
where ipaddress is the IP address for the corresponding network
adapter in the other node. For example, assume that the IP
addresses are set as follows:
Node
Network Name
1
Public Cluster Connection
1
Private Cluster Connection
2
Public Cluster Connection
2
Private Cluster Connection
In this example, you would type:
Ping 192.168.0.172
Cluster Installation
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
Network Adapter IP Address
192.168.0.171
10.1.1.1
192.168.0.172
10.1.1.2
4-11
Advertisement
Table of Contents
