Features - LSI MegaRAID 320 User Manual

1.2

Features

To obtain a driver for an operating system other than the ones listed
above, contact the LSI Logic technical support team at 1-678-728-1250,
or visit our website at http://www.lsilogic.com.
Features of the LSI Logic MegaRAID 320 storage adapters include:
Support for hard disk drives with capacities greater than 8 Gbytes
Online RAID level migration
RAID remapping
No reboot necessary after expansion (for NT 4.0: if virtual sizing is
enabled)
More than 200 Qtags per array
Hardware clustering support on the board
User-specified rebuild rate
Wide Ultra320 LVD SCSI performance up to 320 Mbytes/s
MegaRAID 320-1 has 64 Mbytes of synchronous dynamic random
access memory (SDRAM)
MegaRAID 320-2 supports up to 256 Mbytes of SDRAM; a 32-,
64-, 128-, or 256-Mbyte DIMM can be installed.
MegaRAID 320-2X and -4X support up to 1 Gbyte of double data
rate (DDR) SDRAM; a 32-, 64-, 128-, 256, or 512-Mbyte, or 1-Gbyte
DIMM can be installed.
MegaRAID 320-2, -2X, and -4X support a 64-bit PCI host interface
(note that the -2X and -4X are PCI-X controllers)
MegaRAID 320-1 has one internal and one external SCSI connector;
MegaRAID 320-2 and -2X have two internal and two external SCSI
connectors; MegaRAID 320-4X has two internal and four external
SCSI connectors.
Support for RAID levels 0 (striping), 1 (mirroring), 5 (striping and
parity data across all drives), 10 (mirroring and striping), and 50
(RAID 5 and striping)
Advanced array configuration and management utilities
Features
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
1-3