Adjusting The Sharpness; Resetting The Picture Adjustment; Switching The Screen Mode - Alpine TMX-R1100E User Manual

BASIC OPERATION

Adjusting the Sharpness.

2. Press / on the Remote Control or
on the Sensor Touch Control to select
3. Press or touch / to adjust the SHARPNESS.
SHARPNESS can be adjusted between the range
of -15(SOFT) to +15(HARD).
4. Press ENT or touch to finish adjustment or wait
10 seconds for OSD to shut down. The Setting
Value will be saved automatically.

Resetting the Picture Adjustment.

2. Press / on the Remote Control or /
on the Sensor Touch Control to select [RESET].
3. Press or touch
Picture Adjustment.
• Please press
/
selection otherwise the OSD will be shut down
and left un-reset.

Switching the Screen Mode

Screen Mode can be adjusted to WIDE, ZOOM,
CINEMA and NORMAL modes.
• Each source is independently adjustable.
• Make adjustments within 10 seconds, otherwise
the OSD (On Screen Display) will turn off
automatically.
Sensor Touch Control
/
[SHARPNESS]
/ to reset the
within 10 seconds after
Remote Control Unit
1. Press SEL (SELECT) on the Remote Control for
at least 2 seconds or touch at SELECT on Sensor
Touch Control for at least 2 seconds to open
SETUP Screen.
2. Press SEL (SELECT) or touch SELECT to switch
from Picture Setting to Screen Mode.
3. Press or touch /
DVD
NTSC
PICTURE SCREEN
WIDE
ZOOM
CINEMA
NORMAL
Screen Mode will be switched at every consecutive
press as below.
WIDE ZOOM
WIDE
Normal images are expanded uniformly in the
horizontal direction and are displayed over the
entire screen.
ZOOM
Normal images are expanded uniformly in the
horizontal direction and are displayed over the
entire screen. The expansion ratio will be pulled to
the left and right side of the screen.
CINEMA
Normal images are expanded in the horizontal and
vertical directions. The top and bottom of the image
are cut off. This mode is suited for 16:9 cinema size
to change the Mode.
NTSC
SYSTEM
CINEMA NORMAL
8