Picture Adjustment
Brightness, color, tint, contrast and sharpness are
adjustable.
• Each source is independently adjustable.
• Make adjustments within 10 seconds, otherwise
the OSD (On Screen Display) will turn off
automatically.
• After adjustment, the "FLAT" setting in Visual
EQ changes to "CUSTOM". After resetting
the unit, "CUSTOM" changes back to "FLAT"
1. Press SEL (SELECT) on the Remote Control
for at least 2 seconds or touch at SELECT on
Sensor Touch Control for at least 2 seconds to
open SETUP Screen. Then check if the Picture
Adjustment Mode is being selected.
Sensor Touch Control
Remote Control Unit
Adjusting the Brightness
2. Press
/ on the Remote Control or / on
the Sensor Touch Control to select [Brightness]
3. Press or touch
/
Brightness can be adjusted between the range of
-15(MIN) to +15(MAX).
4. Press ENT or touch to finish adjustment or wait
10 seconds for OSD to shut down. The Setting
Value will be saved automatically.
7
to adjust the brightness.
BASIC OPERATION
Adjusting Color Density.
2. Press
/
on the Remote Control or
on the Sensor Touch Control to select [Color]
3. Press or touch
/
Color can be adjusted between the range of
-15(MIN) to +15(MAX).
4. Press ENT or touch to finish adjustment or wait
10 seconds for OSD to shut down. The Setting
Value will be saved automatically.
Adjusting the Tint
2. Press
/
on the Remote Control or
on the Sensor Touch Control to select [TINT]
3. Press or touch
TINT can be adjusted between the range of
G15(MIN) to R15(MAX).
4. Press ENT or touch to finish adjustment or wait
10 seconds for OSD to shut down. The Setting
Value will be saved automatically.
Adjusting the Contrast
2. Press
/
on the Remote Control or
on the Sensor Touch Control to select
3. Press or touch
/
CONTRAST can be adjusted between the range of
-15(LOW) to +15(HIGH).
4. Press ENT or touch to finish adjustment or wait
10 seconds for OSD to shut down. The Setting
Value will be saved automatically.
to adjust the Color Density.
/
to adjust the TINT.
[CONTRAST]
to adjust the CONTRAST.
/
/
/