Installation By Bracket, Trim Ring; Fixing Bracket; Cutting Trim Ring; Monitor Installation - Alpine TMX-R1100E User Manual

INSTALLATION AND CONNECTIONS
INSTALLATION BY BRACKET,
TRIM RING (*1,2)
Caution Specific knowledge and experience
are needed for this installation.
Please contact to your dealer.
Caution
Do not use electric driver.
It is difficult to control the torque of
electric screw driver; it will not only
damage the screw head but also the
vehicle as well.

FIXING BRACKET

When remove ROOM LAMP for installation.
Use the screw hole that fixed ROOM LAMP
to attach the BRACKET.
*For vehicle with ROOM LAMP fixed with clip,
please find Speed Nut separately.
*It might not be possible to tighten the screw for
vehicle with a gap that the Roof Inner Panel that
fixed with ROOM LAMP. In such case, please
CAUTION
use additional spacer to tighten the screw firmly.
Spacer
Fixing Screw
Please firmly tighten fixing screw.
•
The monitor could fall down if insufficiently
tighten
WARNING
Be careful with the screw size.
•
The monitor could fall down if use the screw
size that is smaller than the fixing hole.
Be careful with the screw length.
•
Using the screw that is longer than the space
between the hole and roof top could damage
CAUTION
the vehicle.

CUTTING TRIM RING.

Use TRIM RING to fill the gap when there is a
gap between Roof Panel and Monitor.
*No need to use TRIM RING if there is no gap.
*Cutting POSITION and SHAPE differ from
1. Using Masking
Tape to mark
according to
the shape of
the Roof Panel.
2. Use Air Saw or
Cutter to cut along
the Marking
WARNING

MONITOR INSTALLATION

Room Lamp
Fixing Panel

FIXING TRIM RING.

*No need to install if TRIM RING is not necessary.
BRACKET
WARNING
vehicle, please carefully check before cutting.
Please firmly fix the TRIM RING then cut.
•
This could cause injury if not fixed firmly.
Fix to the BRACKET.
*Be careful not to route the wiring in obstruction
to the installation.
BRACKET
Screw (M4 x 6)
M4 x 6 (5 PCS)
Screw (M3 x 6)
Please use provided screw to firmly install.
•
Monitor may fallen down if insuffiently
tighten.
Vehicle Roof Panel
Masking Tape
Cutting Position
Rubber Cap
Rubber Cap (5 PCS)
TRIM RING
M3 x 6 (9 PCS)
16