Table of Contents
Advertisement
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
Schedule
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily:
•
Check/tighten loose mounting bolts.
•
Check/replace damaged or worn sanding
belt.
•
Check and repair/replace worn or damaged
wires.
•
Check/resolve any other unsafe condition.
Bi-Monthly:
•
Check/lubricate elevation dovetail way.
•
Check/lubricate Elevation gear.
•
Check/empty air regulator filter reservoir.
Cleaning
Vacuum excess sawdust, and wipe off the remain-
ing dust with a dry cloth.
Use warm soapy water to clean the conveyor belt.
DO NOT use corrosive or solvent-base cleaners.
Extend the life of the sandpaper by regular-
ly using a PRO-STICK
ACCESSORIES on Page 25).
G0644 15" Open-End Wide Belt Sander
sanding pad (refer to
©
Lubrication
The bearings are factory lubricated and sealed
and require no further lubrication. Simply leave
them alone unless they need replacement.
The devices that do require lubrication are the
elevation dovetail way and gears. Keep these
devices adequately lubricated so that elevation
adjustments move smoothly.
To lubricate the elevation gibs:
1.
DISCONNECT
THE
POWER!
2.
Raise and lower the sanding cabinet to
access the entire length of the front and rear
dovetail way (see Figure 29).
Rear
Elevation
Way
Figure 29. Elevation dovetail way on rear of the
sander.
3.
Clean off any debris from the dovetail way
and apply a thin coat of light machine oil.
4.
Move the sanding cabinet through its entire
range of motion to evenly distribute the oil.
lubrication
SANDER
FROM
-27-
Advertisement
Table of Contents
