Table Of Contents - HeatStar HS4030 Operating Instructions And Owner's Manual

High-intensity infrared heaters
Table of Contents

Advertisement

Available languages

Available languages

warning:
Improper installation, adjustment,
alteration, service or maintenance can cause property
damage, injury or death. Read the installation, opera-
tion, and maintenance instructions thoroughly before
installing or servicing this equipment. For assistance
or additional information consult a qualified installer,
service agency, or gas supplier.
warning:
When used without fresh air, heater
may give off CARBoN MoNoXIDe, an odorless poi-
sonous gas. oPeN WINDoW AN INCH oR TWo FoR
FResH AIR WHeN UsING HeATeR.
warning:
This heater is equipped with a PIloT
lIGHT sAFeTY sYsTeM. Do NoT TAMPeR WITH PIloT
lIGHT sAFeTY sYsTeM.
warning:
If heater shuts off, do not relight
until you provide fresh air. If heater keeps shutting off,
have it serviced. Keep burner and control clean. open
door for 5 minutes.
Maintain clearances as shown in Figure 1 or on heater nameplate.
• Do NoT Use MATCH oR oTHeR FlAMe
FoR leAK TesTING.
• Do NoT eXCeeD 1/2 PsI INleT PRessURe To HeATeR.
danger:
Carbon monoxide poisoning may lead to death.
cOntents
General Information .......................................................... 3
Clearances ........................................................................ 3
Gas supply ........................................................................ 3
Gas Pressure ..................................................................... 4
electrical ........................................................................... 5
Thermostat & location ...................................................... 5
Ventilation ........................................................................ 5
operations ........................................................................ 5
Cleaning Information ........................................................ 5
Thermostat ....................................................................... 6
Troubleshooting ................................................................ 7
for flame rectification systems ...................................... 8
Replacement parts ............................................................ 9
Control system replacement parts ....................................12
enerco Group, Inc. |Gas-Fired Infra-Red space Heaters
carbon Monoxide poisoning:
early signs of carbon monoxide poisoning resemble
the flu, with headaches, dizziness, or nausea. If you
have these signs, the heater may not be working
properly. Get fresh air at once! Have heater serviced.
some people are more affected by carbon monoxide
than others. These include pregnant women, persons
with heart or lung disease or anemia, those under the
influence of alcohol, and those at high altitudes.
cautiOn:
• Never connect gas valve or thermostat to line voltage
or a transformer.
• If the infra-red color of the grid becomes dull when
the building furnace is operating, consult gas supplier
on correct gas supply piping sizes.
• This heater is for indoor installation only!
nOte
Gasket binder material used in this heater assem-
bly will temporarily emit an odor and/or vapor. This
condition will clear up in approximately 20 minutes
and thereafter will not reoccur. Refer to page 4 for
ventilation.
tHe state OF caliFOrnia reQuires tHe
FOllOwing warning:
warning:
when using this product contain carbon monoxide,
a chemical known to the state of California to cause
cancer and birth defects (or other reproductive harm).
e2
operating Instructions and owner's Manual
Combustion by-products produced

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents