Table of Contents
Advertisement
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
OPERATING INSTRUCTIONS
READ INSTRUCTIONS CAREFULLY: YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS.
Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow
anyone who has not read these instructions to assemble, light, adjust or operate the heater.
PORTABLE INDUSTRIAL OIL-FIRED
INDIRECT HEATERS
WARNING: If the information in this manual is not followed exactly, a fire or explosion
may result causing property damage, personal injury, or loss of life.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
– Service must be performed by a service agency.
WARNING: Improper adjustment, alteration, service or maintenance can cause injury or property
damage. Refer to this manual for correct installation and operational procedures. For Assistance or
additional information consult a service agency.
WARNING: This is an indirect oil-fired portable heater. It uses air (oxygen) from the area in which
it is used. Provisions for adequate combustion and ventilation air must be provided. Refer to "FRESH
AIR AND VENTILATION" on page 5
ENERCO GROUP, INC., 4560 W. 160
AND OWNER'S MANUAL
HSP70ID
HSP200ID
HSP100ID
HSP300ID
ST., CLEVELAND, OHIO 44135 · 866-447-2194
TH
MODEL#
HSP70ID HSP100ID
HSP200ID HSP300ID
Advertisement
Table of Contents
Related Manuals for HeatStar HSP70ID
Summary of Contents for HeatStar HSP70ID
- Page 1 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! OPERATING INSTRUCTIONS MODEL# HSP70ID HSP100ID AND OWNER’S MANUAL HSP200ID HSP300ID READ INSTRUCTIONS CAREFULLY: YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS. Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
-
Page 2: Table Of Contents
UNPACKING & ASSEMBLY ......... 4 WWW.HEATSTARBYENERCO.COM FRESH AIR AND VENTILATION ........5 OPERATION ............... 6 In order to provide the best service possible HEATSTAR is now giving you more ways to get in touch with us. Find informational TRANSPORTATION............. 7 videos at: STORAGE.............. -
Page 3: Clearances To Combustibles
Unlike direct combustion heaters, which send OPEN FLAME combustion products into the space with hot • DO NOT OPERATE HEATER WHERE air, These HEATSTAR PRO indirect-fired keep FLAMMABLE LIQUIDS OR VAPORS MAY BE combustion products separated from clean hot PRESENT air by means of a heat exchanger. -
Page 4: Unpacking & Assembly
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! Please observe the following precautions regarding capacity, type of nozzles and pump when operating your HEATSTAR product. pressure. An increase in burner power could damage the heater. 1. Check the heater thoroughly for damage. DO NOT operate a damaged heater. -
Page 5: Fresh Air And Ventilation
3), which connects to the heater chimney installed in situations (Figure 4), requires a diameter of 4.7 inches or where downdrafts greater for the HSP70ID model and 5.9 inches occur. CHIMNEY or greater for the HSP100ID, HSP200ID, and • Horizontal runs of FIGURE 4: HSP300ID models. -
Page 6: Operation
Table 3 to determine the approximate minimum required opening for ventilation of the space containing the heater unit. THERMOSTAT SOCKET TABLE 3: FRESH AIR REQUIREMENTS THERMOSTAT SOCKET CAP HSP70ID 0.52 ft² CONTROL PANEL FIGURE 5: HSP100ID 0.78 ft² TURNING ON THE HEATER HSP200ID 1.25 ft²... -
Page 7: Transportation
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! CONTROL AND SAFETY DEVICES RESETTING THE HEATER The appliance stops when an anomaly occurs. SAFETY THERMOSTAT If the reset button turns on with a steady red The high limit safety thermostat blocks machine light it means the heater needs to be reset. - Page 8 WARNING: REPLACING THE INTAKE FUEL FILTER (HSP70ID) Never service heater while it is plugged in, The in-line filter (Figure 10) of the HSP70ID model operating or hot. Severe burns or electrical can be replaced by the following procedure: shock can occur.
-
Page 9: Troubleshooting
External substances or dirt in the fuel • Empty, rinse and refill the tank circuit • Rinse the filter • Contact HEATSTAR customer service. External substances or dirt in the fuel • Empty and refill the tank with clean fuel circuit •... -
Page 10: Parts List And Diagram
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM PARTS LIST AND DIAGRAM HSP70ID NOTE: Not all parts available. For questions contact manufacturer. WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury. - Page 11 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP70ID PART DESCRIPTION PART DESCRIPTION 51076 THERMOSTAT BULB CLIP 51007 FUEL LINE - FILTER-TANK(RETURN LINE)
- Page 12 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP100ID Portable Indirect Oil-Fired Heaters Installation Instructions and Owner’s Manual...
- Page 13 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP100ID PART DESCRIPTION PART DESCRIPTION 51018 CHIMNEY 51320 HANDLE 51064 PHOTOCELL SENSOR 51134 TANK CAP 51530 BURNER HEAD 51242...
- Page 14 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP200ID Portable Indirect Oil-Fired Heaters Installation Instructions and Owner’s Manual...
-
Page 15: Wiring
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP200ID PART DESCRIPTION PART DESCRIPTION 51077 PUMP VALVE POWER CORD 51018 CHIMNEY 51320 HANDLE 51064 PHOTOCELL SENSOR 51530 BURNER HEAD... - Page 16 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP300ID Portable Indirect Oil-Fired Heaters Installation Instructions and Owner’s Manual...
- Page 17 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST AND DIAGRAM HSP300ID PART DESCRIPTION PART DESCRIPTION 51077 PUMP VALVE POWER CORD 51018 CHIMNEY 51317 HANDLE 51064 PHOTOCELL SENSOR 51055 BURNER HEAD...
- Page 18 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! PARTS LIST: ACCESSORY CHART PART # DESCRIPTION HSP70ID HSP100ID HSP200ID HSP300ID F105107 KIT 12" Duct adapter ON BOARD N/A F105111 KIT 14"...
- Page 19 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! WIRING HSP70ID WIRING DIAGRAM FO: Photoresistance TA: Ambient thermostat FR: Filter noise FPH: Pre-heating filter M: Motor R: Relay...
- Page 20 CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. REPLACEMENT PARTS ORDERING INFORMATION: PURCHASING: Accessories may be purchased at any HEATSTAR by Enerco local dealer or direct from the factory FOR INFORMATION REGARDING SERVICE Please call Toll-Free 866-447-2194 WWW.HEATSTARBYENERCO.COM...
Need help?
Do you have a question about the HSP70ID and is the answer not in the manual?
Questions and answers