Starting Serial Number: SKu-09001001 OpERATING INSTRuCTIONS Model # HS50K, HS75KT, AND OWNER’S MANuAl HS125KT, HS175KT, HS210KT READ INSTRuCTIONS CAREFullY: Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
THE HEATER. • PLUG ELECTRICAL CORD INTO A PROPERLY GROUN- DED THREE-PRONG RECEPTACLE. HS50K & HS75KT WARNING: Not suitable for use on wood floors or other combustible materials. When used the heater should rest on a suitable insulating material at least 1 inch thick and extending 3 feet or more beyond the heater in all directions.
Never use in areas normally for habitation and /or where • headache children may be present. • dizziness 10. Operate only on a stable, level surface. (HS50K & HS75KT – • burning eyes and nose See wood floor warning). • nausea 11.
Heater does not have a strong consistent flame. HEATER START up Heater smokes and spits raw fuel. HS50K: Plug the heater into a grounded 115V, 60 Hz, 1 Ø Nose cone does not get cherry red. outlet. HS75KT, HS125KT, HS175KT & HS210KT: Turn thermostat to lowest setting, make sure “On/Off”...
Page 5
parts should be repaired or replaced before using heater When the heater is working normally: again. Check heater operation to be sure it is operating The flame is contained within the heater. normally (See “Servicing” section for description of normal The flame is essentially yellow.
DIAGNOSTIC SAFETY SHuTDOWN AND TROuBlE SHOOTING These instructions are applicable for HS50K, HS75KT, HS125KT, HS175KT, HS210KT SYMpTOM TROuBlE SHOOTING High limit switch Open Circuit Make sure heater is cooled off, toggle switch to “OFF” position, wait 5 minutes and retry.
WIRING dIAGRAM 18AWG GRN HI-LIMIT ON/OFF SWITCH SWITCH 18AWG BLK 18AWG YELL 18AWG WHT 18AWG YELL CORD SET THERMOSTAT 18AWG BLUE 75KT,125KT,175KT,210KT ONLY 18AWG PURPLE FLAME CONTROL SCHEMATIC 18AWG PURPLE (connections may not be in same position on circuit board) 17AWG BLK ELECTR0DE 18AWG ORG...
OpERATING INSTRuCTIONS Model # HS50K, HS75KT, AND OWNER’S MANuAl HS125KT, HS175KT, HS210KT WARNING: USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY.
Page 16
fonctionnement instructions d’utilisation Guide kérosène pulsé à chauffage Appareil Inc. Products, Technical Enerco graduellement, augmentera pression combustible. d'air débit diminution entraînera gicleur conduits éventuellement obstruera d'entrée l'aube causée carbone combustible saleté L'accumulation GICLEUR. sec. doux chiffon d'un l'aide à cadmium cellule vitrée partie...
Page 17
Placez HS210KT HS175KT HS125KT, HS75KT, boulons l'aide à poignées cordon guides Fixez l'appareil. rebranchez puis minutes cinq attendez l'appareil, Débranchez HS50K écrous. tous Serrez page Voir vissés. tous soient qu'ils avant serrez main HS210KT) HS175KT HS125KT, HS75KT, (HS50K, à écrous Vissez roues.
Page 18
N'utilisez d'informer responsable l'utilisateur personnes, d'autres bois.) planchers présence fonctionner doit chauffage l'appareil Lorsque sujet l'avertissement Voir – HS75KT (HS50K l'appareil. fonctionner faire pour modifiés niveau. stables surfaces uniquement Utilisez contournés être doivent sécurité systèmes même, enfants. présents sont où...
Page 19
Lors combustibles. matériaux d'autres bois planchers utilisé être pour conçu HS75KT HS50K MODÈLES RELATIF AVERTISSEMENT TERRE. À MISE ADÉQUATEMENT BROCHES TROIS À PRISE DANS ÉLECTRIQUE CORDON BRANCHEZ • CHAUFFAGE. L'APPAREIL CUISSON...
Page 20
à Interdisez ultérieurement. référer vous pour instructions Conservez instructions. toutes observez Lisez INSTRUCTIONS. SOIGNEUSEMENT LISEZ FONCTIONNEMENT HS210KT HS175KT, HS125KT, INSTRUCTIONS HS75KT, HS50K, D'UTILISATION GUIDE n° Modèle SKU-09001001 série Numéro...
Need help?
Do you have a question about the HS50K and is the answer not in the manual?
Questions and answers