Advertisement
Quick Links
OPERATING INSTRUCTIO NS AND OWNER'S MANUAL
READ INSTRUCTI O NS CAREFULLY:
and follow all instructions. Place instructions in
a safe place for future reference. Do not allow
anyone who has not read these instructions to
assemble, light, adjust or operate the heater.
NATURAL GAS/ LPG FIRED
DIRECT FIRED HEATER
If the information in this manual is not followed exactly, afire or explosion
WARNING:
may result causing property damage, personal injury or loss of life.
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
— Service must be performed by a qualified service agency.
This is a vented portable heater. It uses air (oxygen) from the area in which it is used. Adequate
combustion air and ventilation must be provided. Refer to page 5.
ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 800-251-0001
Read
HEATSTAR
BY ENERCO
HS4000 NG/LP
08/11
50401
Advertisement
Related Manuals for HeatStar HS4000 NG/LP
Summary of Contents for HeatStar HS4000 NG/LP
- Page 1 Place instructions in BY ENERCO a safe place for future reference. Do not allow anyone who has not read these instructions to HS4000 NG/LP assemble, light, adjust or operate the heater. NATURAL GAS/ LPG FIRED DIRECT FIRED HEATER...
-
Page 2: Table Of Contents
WARNING : WARNING : YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS, NOT FOR HOME OR RECREATIONAL V EHICLE USE SO PLEASE READ THESE INSTRUCTIONS BEFORE YOU OPERATE THIS H EATER. WARNING : GENERAL H AZARD WARNING : FIRE, BURN, INHALATION, AND EXPLOSION HAZARD. KEEP SOLID COMBUSTIBLES, SUCH AS BUILDING MA - FAILURE TO COMPLY WITH THE PRECAUTIONS AND TERIALS, PAPER OR CARDBOARD, A SAFE DISTANCE... -
Page 3: Warnings
WARNING : The heater is designed and approved for use as a construction heater in accordance with Standard ANSI Z83,7 CGA 2.14. CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS. Other standards govern the use of fuel gases and heat producing products in specific applications.Your local authority can advise you about these. -
Page 4: Specifications
TECHNICAL SPECIFICATIONS GE/N 250C GE/N 400C min 7" w.c. min 7" w.c. Supply pressure [in WC] max 10" w.c. max 10" w.c. Selector valve position Normal Heat input [BTU/h] 254.684 403.753 altitude 0 - 2,000 ft above Natural gas Manifold pressure [in WC] 4,33 4,40... - Page 5 CONTROL PANEL - TABLEAU DE COMMANDE Fig. 1 COMBUSTION CHAMBER CONTROL FLAME ELECTRONIC RESET BURNER HEATING SWITCH DIFFUSION RING ROOM THERMOSTAT PLUG FLAME GUARD SHIELD POWER CONTROL LAMP POWER CORD COOLING FAN IONIZATION ELECTRODE VENTILATION MODE SWITCH IGNITION ELECTRODE PHASE / NEUTRAL LINE TEST PUSH BUTTON MANIFOLD ASSEMBLY GE/N 250 GE/N 400...
-
Page 6: Safety Devices
DESCRIPTION • Make sure heater is inspected before each use, and at least annually by a qualified service person. The hot air generator is designed for heating medium and large • After use make sure the disconnecting switch is off. ventilated premises, for which a fixed or mobile heating system is When using any type of heater it is obligatory: required. -
Page 7: Operation
ACCORDANCE WITH THE REQUIREMENTS OF THE CAN/CGA-B149.1 OR CAN/CGAB149.2 INSTALLATION CODES. A conversion label shall be applied adiacent to the Rating Label: THIS APPLIANCE HAS BEEN CONVERTED FOR USE AT AN ALTITUDE OF ___________ FEET (ABOVE 2000 FEET) Orifice size: ______________________________________ 1 Main gas pipe 3 Antivibrating coupling... -
Page 8: Maintenance
Turning ON TRANSPORT AND HANDLING • Make sure switch (9) is on “0”; WARNING : • Power the heater by means of the sectioning switch on the switchboard; Before moving the unit: • If the unit is operated manually (without any thermostat or any •... -
Page 9: Troubleshooting
TROUBLESHOOTING GUIDE FAULTS CAUSES REMEDIES • Check power specifications • No power supply • Check power connections • Check fuse integrity • Main switch in wrong position • Select correct position • The generator fails to start • Check thermostat position •... -
Page 10: Wiring Diagrams
WIRING DIAGRAM CONTROL BOX MOTOR RELAY FUSE CONTROL LAMP IONIZATION ELECTRODE GAS TRAIN FUSE COOLING MOTOR POVERHEAT THEMOSTAT VENTILATION MODE SWITCH PRESSURE SWITCH 20 Pa POST-VENTILATION RELAY ROOM THERMOSTAT PLUG TRANSFORMER H.T. CAPACITOR HEATING SWITCH ENERCO GROUP, INC. |Indirect Fired Portable Heater Operating Instructions and Owner’s Manual... - Page 11 ENERCO GROUP, INC. |Indirect Fired Portable Heater Operating Instructions and Owner’s Manual...
- Page 12 ENERCO GROUP, INC. |Indirect Fired Portable Heater Operating Instructions and Owner’s Manual...
- Page 13 ENERCO GROUP, INC. |Indirect Fired Portable Heater Operating Instructions and Owner’s Manual...
- Page 14 DIRECT FROM TH E FACTORY AND MUST B E INSTALLED BY A QUA LIFIED SERVICE AGENCY. PARTS O RDERING IN FORM ATI ON: PURC HASING : Accessories may be purchased at any Mr. Heater/HeatStar local dealer or direct from the factory FOR IN FORM ATI ON REGARDING SER VICE Please call Toll-Free 800-251-0001 •...
Need help?
Do you have a question about the HS4000 NG/LP and is the answer not in the manual?
Questions and answers