Section 2: Circuit Requirements; 110V Operation - Grizzly G0538 Owner's Manual

SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
Amperage Draw
The Model G0538 motor draws the following
amps under maximum load:
Motor Draw .............................................. 4 Amps
Circuit Recommendations
We recommend connecting this machine to a
dedicated circuit with a verified ground, using the
circuit breaker size given below. Never replace a
circuit breaker with one of higher amperage with-
out consulting a qualified electrician to ensure
compliance with wiring codes. If you are unsure
about the wiring codes in your area or you
plan to connect your machine to a shared cir-
cuit, you may create a fire hazard—consult a
qualified electrician to reduce this risk.
Circuit Breaker ....................................... 10 Amps
Plug⁄Receptacle Type
Included Plug Type ........................... NEMA 5-15
Figure 2. Typical type 5-15 plug and receptacle.
G0538 Oscillating Spindle Sander
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure
checking with a qualified
electrician!
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
We do not recommend the use of extension
cords, if you find it absolutely necessary:
• Use at least a 16 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
compliance by
-9-