Table of Contents
Advertisement
Groove cutting:
Beading is commonly defined as cutting a groove
or bead in the face of a board.
1.
Mount a router bit into your router according
to the router manufacturer's instructions.
2.
Snap one of the table inserts into the
recessed hole on the table. Use the insert
with the smallest hole that still allows the bit
free rotation.
3.
Raise the bit to the desired height.
4.
Loosen the threaded knobs that secure the
main fence.
5.
Adjust the main fence until the center of the
V-groove bit is the desired distance away as
shown in Figure 21 & 22.
Distance From
Edge Of Board
To Center Of
V-Groove
Figure 21. Groove cutting setup.
(Top View)
H3114 Router Table
Distance From
Edge Of Board
To Center Of
V-Groove
Figure 22. Groove cutting setup.
(Side View)
6.
Tighten the main fence threaded knobs.
7.
Double check that the router is secured to the
table. If it is, the router table is ready for use.
-15-
Advertisement
Table of Contents
