Table of Contents
Advertisement
To secure the router table to a workbench:
The bottom of each leg has two holes ( Figure 16 )
used for mounting the router table to the work-
bench. Secure the router table to the workbench
with wood screws and washers.
Figure 16. Router table mounting holes.
H3114 Router Table
To assemble the miter gauge (Figure 17 & 18):
1.
Attach the miter body to the miter bar with the
supplied M4 x 12 tap screw.
2.
Place the M8 flat washer over the M8-1.0 x
12 knob bolt.
3.
Slide the M8-1.0 x 12 knob bolt through the
miter body slot and thread it into the miter
bar.
Miter Body
Tap Screw
Flat Washer
Figure 17. Miter gauge components.
Figure 18. Assembled miter gauge.
Miter Bar
Knob Bolt
-13-
Advertisement
Table of Contents
