Grizzly H3114 Instruction Manual page 13

7. Hold the router and rotate the clamps over
the router base as shown in Figure 9 .
Clamp Position
Figure 9. Rotating a clamp over
the router base.
8.
Tighten the M5-0.8 keps nuts enough to pre-
vent the router from moving, but DO NOT
fully tighten them at this time.
9. Turn the router table top-side up.
10. Loosen the M5-0.8 keps nuts several turns
and reposition the router until the router spin-
dle is centered in the round table cut-out
when viewed from above.
11. Tighten the M5-0.8 keps nuts ( Figure 10 ).
Figure 10. Correctly clamped router.
H3114 Router Table
To assemble the fence:
1. Attach the spring to the retractable guard as
shown in Figure 11.
Spring
Figure 11. Correct spring placement.
2.
Insert the retractable guard into the fence
and secure the guard with the supplied M4 x
12 tap screw and the M5 flat washer (Figure
12). The bit guard should move freely with no
binding on the fence. If binding occurs, light-
ly sand or file the contact areas.
Figure 12. Correctly installed guard.
Retractable Guard
-11-