Table of Contents
Advertisement
4.
If you will be employing the HP external speakers, the bare speaker wire should be connected to
the matching color coded speaker connector for the Right and Left speaker, as in
the speakers (sold separately) on page
Figure 3-21
5.
If you want to remotely control and manage the display with the RS-232 Serial interface, attach
one end of an RS-232 cable to the RS-232 input (5) port (With the display lying on its face, the
input port is below the output port) and connect the other end to the serial interface port of the
media player/computer.
If you will be connecting more displays in a series (daisy chain), connect one end of a second
RS-232 cable to the output (upper) port of the display and the other end of the RS-232 cable to
the input port of the next display in the chain. (See
on page 22
Figure 3-22
6.
The USB port is for attaching a color-calibration device such as the HP DreamColor Display
Calibration Solution and is also used in the event of a firmware upgrade. Neither USB device is
plugged in until the time of use. However, if access to the USB port (6) will be limited once the
display is mounted, you can attach a USB extension cable now.
Figure 3-23
18
Chapter 3 Setting up the display
External speaker connections
for more details).
RS-232
USB
8.
Connecting multiple displays to one player
Connecting
ENWW
Advertisement
Table of Contents
