Table of Contents
Advertisement
Installation
9
(for qualified installers only)
4. Place sections 3 and 4 as shown below.
Figure 7: Three Sections Assembled
Figure 8: All 4 Sections Assembled
5. Attach the sections, installing the bolts, washers, and nuts in each section, but do not tighten yet. There
are top and bottom bolts for each section. See the photos below.
Figure 9: Attaching Sections
Figure 10: Attached Section With Loose Bolts
6. Tighten each bolt with the wrenches in several turns, alternating the bolts. This will help align the firepit.
Figure 11: ¾" Crescent and Ratchet Wrenches
Figure 12: Tightening the Bolts
© Travis Industries, Inc.
4110603
100-01265_000
Advertisement
Table of Contents
