Table of Contents
Advertisement
8
Before You Begin
!
Read this entire manual before you use your new firepit, especially the section "Safety
Precautions" on page 13. Failure to follow the instructions may result in property damage,
bodily injury, or death.
NOTE: The sections of the firepit are heavy, and may require two people to lift them into place.
Tools Needed
Two ¾" wrenches
Installation Instructions
NOTE: The nuts, bolts, and washers attaching the firepit to the pallet are used for installation. Do not throw
these away after detaching the firepit from the pallet.
NOTE: The 3‐foot model is shipped in 2 halves, 2 sections per half. You may want to loosen the bolts before
assembling, to ensure correct alignment.
1. Determine the location of the firepit. Make sure all clearances are met (see page 6).
2. Prepare the firepit location. We recommend 3" (77mm) of compacted sand or gravel under the firepit,
extending 12" (305mm) beyond the outside edge.
3. Place section 1 as shown in Figure 5; place section 2 as shown in Figure 6. The pipe at the right of each
section fits into the hole at the left of the next section, so that the holes in the brackets align.
NOTE: Each section of the firepit is numbered and must be assembled sequentially to ensure proper
alignment. You can identify each section by the number of tack welds inside the corner box (see Figure
4). Section 1 has 1 tack weld; section 2 has 2 tack welds, and so on.
NOTE: Do not bolt the sections together yet.
Figure 5: 1st Section
© Travis Industries, Inc.
Installation
Figure 4: Location of Tack Weld
(for qualified installers only)
Figure 6: 1st and 2nd Sections Assembled
4110603
100-01265_000
Advertisement
Table of Contents
