Maintenance; Display Codes - Haier HWM70-1201 User Manual

18

dispLAy codes

DISPLAy CODES AND SPECIAL fUNCTIONS
coDes causes
err1 ¬ Door is not properly shut.
err2 ¬ Drainage error, water not emptied within 6
minutes.
err3 ¬ Temperature sensor not properly connected or
damaged.
err4 ¬ heater error (appears at the end of a cycle).
err5 ¬Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
err6 ¬ motor error.
err7 ¬ motor error.
err8 ¬ Water exceeds protective level.
end ¬ end of wash cycle.
1:25 ¬The remaining time is 1 hour 25 minutes.
19:25 ¬status information:preset time for delayed operation.
unb after the last rinsing cycle finishes,spinning fails completely due to unbalance of the laundry.
¬ power-off memory function: in case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.

maintenance

soluTions
_ shut the door properly.
_ clean the filter and check the drain hose for blockage. if error
still exists, please contact the maintenance personnel.
_ contact the maintenance personnel.
_ reduce load and then start washing again. if problem still
exists, please contact the maintenance personnel.
_ make sure that tap is turned on, and water pressure is normal.
if problem still exists, please contact the maintenance personnel.
_ install drain hose within 80-100 cm of height.
_ make sure the drain hose is not in water.
_ contact the maintenance personnel.
_ contact the maintenance personnel.
_ contact the maintenance personnel.