Table of Contents
Advertisement
Cleaning and Maintenance
Maintenance
Remove the power plug before carrying out any cleaning and maintenance.
Clean the lint filter(s) and detergent drawer after each wash,otherwise it may influence
your next use.
Clean the detergent drawer and install
back to the original position.
1.Slightly lift up the drawer and push
it out.
2.Rinse the drawer with water and brush
it until it is clean.
3.Insert the drawer back to the appliance.
Remove
To prevent blockage of water supply by
dirt and dust, clean the filter at water
inlet valve by brushing it every 2
months.
If the washing machine case is dirty, wipe it with a damp cloth.
Do not wash directly with water.
Use a soft cloth with soap liquid to clean the
washing machine case.
Do not wipe machine with thinners, petrol,
alcohol or other hash solvents.
1.After washing cycle finished, turn off the water faucet.(If needed, you can remove
the water inlet hose).
2.Do not store water inside the tub for a long period of time without complete a wash
cycle. Drain out the water completely after wash.
3.Hang the power cord and drain hose properly.
4.Use a soft cloth to wipe out water droplets on the washing machine case. Leave
the lid opens for an hour to prevent formation of moisture and odours.
The lint filter must be used during washing.
Clean the lint filter after use. How to
remove and install the lint filter:
1.Press down the upper area of the filter
case to remove. (figure 1)
2.Unlock the front cover. (figure 2)
3.Clean the filter with running water and a
brush.
4.When cleaning is completed, put the filter
back to the filter case.
5.Close the cover and reinsert the filter case
back to the original position.
6.Make sure the filter case fits in completely,
otherwise it will affect the washing
performance.
The front cover of the lint filter
The back cover of the lint filter
Up
Dismantle
Install
Dismantle
Down
Figure 1
15
Up
Install
Down
Figure 2
Advertisement
Table of Contents
