Important Safety Information - Haier HWM70-1201 User Manual

Automatic front loading washing machine
Table of Contents

Advertisement

20

Important Safety InformatIon

Do not use a multiple socket extension cord. a separate earthed socket is required which shall be accessible at all times.
if the mains cord becomes damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person with a
lead of the same type and rating to avoid a hazard.
never remove the plug from the socket by pulling on the cord, always grasp the plug.
The door may get hot during use, do not touch it and keep children away whilst the machine is operating.
never open the detergent drawer while the machine is running.hot water and detergent might be ejected.
When installing the product, make sure the mains cord is not trapped or twisted.
Warnings:
This appliance is inTenDeD for DomesTic use only, commercial or any oTher
use may inValiDaTe The WarranTy anD mighT be Dangerous.
never touch or operate the machine with wet hands or when bare footed.
Do not put the machine on a carpet that can block the ventilation slots on the bottom of the unit.
Do not install this machine outdoors or in a damp place or expose it to rain.
Do not install this product near a heat source or in direct sunlight.
Do not place any object on the machine when it is operating.
This appliance must be earthed.
if you are disposing of an old appliance,disable the door lock to avoid entrapment of children when playing and cut off the mains
cord close to the machine.
The appliance must be connected to a 220-240 volts 50 cycle ac supply by means of a three pin socket, suitably earthed and the
outlet should be protected by a 15 amp fuse.
WaTer connecTion
The product should be connected to the water main using new hose sets, old hose sets should not be re used.
The water pressure must not be less than 0.03mpa.
connect to the water main using a standard 3/4 inch threaded tap outlet.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hwm80-1401

Table of Contents