Dial-Out Setup - Speco DVR-4TH User Manual

User's Manual

Dial-out Setup

The Dial-out function enables the user to establish dial-up modem
communication to and from the DVR-4TH/ 8TH/ 16TH series unit for remote
notification use. The user can connect one modem to the DVR-4TH/ 8TH/
16TH series unit. For more information for dial-up setting on PC, see
appendix Dial-up Connections via Modem.
In the Network Setup menu, select <Dial-out Setup> and press ENTER to
enter the Dial-out menu. The menu displays as follows.
1. Dial-out DHCP
2. Dial-out IP
3. Dial-out Netmask
4. Dial-out Gateway
5. Dial-out DNS
6. Phone Number
7. Dial-out Account
8. Dial-out Password
9. Dial-out Idle Time
10. Dial-out Max Time
11. Connect
Dial-out DHCP
This item allows the user to obtain a dynamic IP address from a DHCP
(Dynamic Host Configuration Protocol) server over a modem connection. If
the item is enabled (ON), a dynamic IP will be assigned to the DVR-4TH/
8TH/ 16THseries unit. In this case, the user does not need to configure a
static IP and the following settings will be "read only."
Select <ON> to enable the DHCP function, or <OFF> to set the dial-out IP
address, Netmask, Gateway and DNS manually. The default setting is <ON>.
Dial-out IP
This item is for setting a static IP address that identifies the DVR-4TH/ 8TH/
16TH series unit over a modem connection. Set the <Dial-out DHCP> to
<OFF> for accessing this item.
Move the cursor over <Dial-out IP> and press ENTER, then press UP /
DOWN keys to change the values in the selected field.
76
NOTE: The Dial-out Service is not available if there is no modem
connected to the unit.
Dial-out Setup
OFF
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0 Min
0 Min
No
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 01/09