Network Restart; Modem Setup; Dial-In Setup - Speco DVR-4TH User Manual

Network Restart

Network restart is required after changing network settings. Select
<Yes> to restart the network connection. After pressing ENTER, a message
"Network restarting Please stand by" will be shown on the screen. A message
box will be displayed within 30 seconds.
The "√" symbol indicates that the device is working properly whereas the "X"
symbol indicates that the device is NOT working properly. The definitions of
the items on the message box are described below.
5.1.7.3

Modem Setup

The DVR-4TH/ 8TH/ 16TH series unit can connect to the internet via an
external installed modem.

1. Dial-in Setup

2. Dial-out Setup
3. Dial Port Selection
Dial-in Setup
The Dial-in function enables the user to establish dial-up modem
communication to and from the DVR-4TH/ 8TH/ 16TH series unit for remote
software use. The user is allowed to connect only one modem to a DVR-4TH/
8TH/ 16TH series unit.
For more information on dial-up setting on PC, see appendix Dial-up
Connections via Modem.
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 01/09
Network restart.............................
UPnP NAT setting..........................
DDNS submitted...........................
WAN connection...........................
Modem Setup
NOTE: The Dial-in Service is not available if there is no modem
connected to the unit.
User's Manual
√
X
√
√
NONE
73