FireplaceXtrordinair 35 Custom Builder Owner's Manual page 46

Optional Equipment
4 4
4 Attach the on/off wires to the valve following the directions below.
5 Install the electrical connection to the fireplace following the directions below.
WARNING: Make sure power is
off from the power lead before
conducting any wiring.
6 If using the modulating remote, install the heat shield following the directions below.
Place the top portion of the heat shield over the lower portion.
a
Bend the tabs over to lock the two pieces together.
Travis Industries
Attach these two
wires to the front of
the gas control valve.
Remove the cover from the
a
fireplace junction box.
Attach the common (white), ground (exposed or green)
c
wires, and hot (black) wires from the power source to the
electrical connector (attached to the fireplace).
(for qualified installers only)
Insert the sheathed cable from the power source through
b
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Electrical
Connector
Position the receiver heat shield at the front of
b
the fireplace near the gas control valve.
9 3 5 0 8 1 1 6
Standard
Screwdriver
Replace the
cover removed
d
in step "a".
0 3 1 0 0 0