Table of Contents
Advertisement
User's Manual
2. After the slave drive has been installed, it needs to be activated in the menu, as
follows:
Power on the DHT. Only the master drive will be detected.
Press Menu on the front of the DHT (or on the remote) then arrow down to the
HDD/REC SET menu and press Enter.
Arrow down to HDD SLAVE and press Enter. This will change HDD SLAVE to YES.
Arrow down to Exit and press Enter.
3. Power down the DHT for about two minutes (from the switch on the back.)
4. Power on the DHT. It should detect the master drive, then the slave drive
5. Press the Enter button on the remote. The System Information will display on the
screen. Confirm that both the master and the slave drives are listed.
3 0 0 A l d e n R o a d • M a r k h a m • O n t a r i o • C a n a d a • L 3 R 4 C 1
t e l : ( 9 0 5 ) 9 4 6 - 8 4 7 7 •
D i g i m e r g e T e c h n o l o g i e s I n c .
f a x : ( 9 0 5 ) 9 4 7 - 0 1 3 8
38
DHT 300 SERIES
NTSC Version
Advertisement
Table of Contents
