User Options - ALLEN & HEATH MixWizard WZ314:4:2 User Manual

User Options

REMOVE 4x M4 POZI SCREWS PER SIDE
REMOVE SIDE TRIMS
REMOVE M4 POZI SCREW PER SIDE
ROTATE POD
REMOVE 3x M3 TORX SCREWS
ROTATE POD
REMOVE 4x M3 TORX SCREWS
LIFT OFF BASE
MONO INPUT
AUX PRE/POST FADER
DIRECT OUT PRE/POST FADER
AUX PRE/POST INSERT/EQ
24
The MixWizard has a versatile architecture which
should satisfy most applications you may encounter
without modification. However, the following internal
options
applications that may demand them.
required to the internal assemblies.
convenience, pluggable jumper links are used in
most places.
Remove the base
trims if fitted using a Pozi crosshead screwdriver.
Release the two M4 Pozi head pod securing screws
and rotate the connector pod to gain access to the
three M3 rear base fixing screws.
starhead screwdriver to remove these. Rotate the
pod again to remove the four M3 underside base
screws using the Torx driver. Carefully lift off the
base.
Configure the internal options
options required.
required positions. Make sure they are pressed fully
home. Check that all channels are correctly set and
all options fitted according to their instructions. Make
sure that no debris or parts are left loose inside the
console.
Refit the base
Refit the fixing screws. Lock the connector pod in
the required position using the securing screws.
Refit the side trims if required.
IMPORTANT:
jumpers are correctly set as required. Errors on one
or more channels now may cause user problems
later. We recommend that you write the repositioned
jumper settings on a label and adhere this to the rear
panel.
other users of the console.
STEREO INPUT
AUX STEREO/MONO
MATRIX AB
BALANCE
AUX PRE/POST FADER
AUX 1-4
BALANCE
provide alternative settings
Start by removing the side
Set the option jumpers to the
Carefully reposition the base.
Check carefully that all channel
This would provide a helpful reference to
MASTER L
GROUP
AUX5
BALANCE
TB MIC
+48V
3
WZ 14:4:2
for those
Access is
For user
Use a Torx
Fit the
MASTER R
AUX6
BALANCE
User Guide