Set Up Instructions - Stamina Elite Total Body Owner's Manual

SET UP INSTRUCTIONS

TOTAL BODY RECUMBENT BIKE
Place the
TOTAL BODY RECUMBENT BIKE
the
RECUMBENT BIKE
vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the
RECUMBENT BIKE
TOTAL BODY RECUMBENT BIKE
LEVELING: Place the
on the floor without rocking. Adjust the
more support for the base of the TOTAL BODY RECUMBENT BIKE.
TOTAL BODY RECUMBENT BIKE
MOVING: The
STABILIZER(8).
RECUMBENT BIKE
FUNCTION INSPECTION:
TOTAL BODY RECUMBENT BIKE
Visually inspect the
illustration. Check the function of the
handlebar slowly through one complete revolution to verify that the drive train functions properly. Adjust the
TENSION KNOB(21)
CAUTION:
Locate and read the
Make sure that all users read the
is approximately 49 5/8" long x 23 5/8" wide x 48 5/8" tall. (These dimensions may
. Make sure that adequate space is available for access to and passage around the
.
TOTAL BODY RECUMBENT BIKE
Lift up from
.
TOTAL BODY RECUMBENT BIKE
and verify that it functions properly.
Warning Label(108)
in the area where it will be used. It is recommended that
be placed on an equipment mat. The
on a flat surface and equipment mat to set it
STAND(65)
has a pair of
REAR STABILIZER(9)
to verify that assembly is as shown in the above
TOTAL BODY RECUMBENT BIKE
on the
Warning Label(108).
11
REAR FRAME(2)
under the
WHEELS(76)
to move the
Equipment Mat
. Turn the pedal and then
TOTAL BODY
TOTAL BODY
to get
FRONT
on the
TOTAL BODY
.